4.2 - 6 MTH800 TETRA Handportable Terminal / Basic Service Manual TEST SETUP & TESTING 440-470MHz
If the displayed values are different, please change the IFR setting to be similar
to the values below.
Power On Registration: required
Power Off Deregistration: required
Priority Cell: yes
Minimum Mode Service: never used
Migration: not supported
System Wide Services: normal mode
17. Press “More” softkey.
TETRA Voice Service: supported
Circuit Mode Data Service: not supported
(Reserved): not available
SNDCD Service: not available
Air Interface Encryption: not available
Advanced Link: not supported
18. Press the “Return” softkey.
19. Press the “Neighbr Cell” softkey.
20. Verify that the following NEIGHBOUR CELL INFO values are displayed:
Note: If the displayed values are different, please change the IFR setting to be
similar to the values below.
NEIGHBOUR CELL BROADCAST: SUPPORTED
BROADCAST INTERVAL: 10s
NEIGHBOUR CELL CHANNEL: 0000
NEIGHBOUR CELL LOCATION AREA: 00001
NEIGHBOUR CELL IDENTIFIER: 01
SLOW RE-SELECT THRESHOLD: 10dB
PRESS “MORE” softkey
SLOW RE-SELECT HYSTERESIS: 10dB
To Next Page
Loading...
