6809493A69-O May 18, 2005 19
Level 1 and 2 Service Manual Tools and Test Equipment
Tools and Test Equipment
The following table lists tools and test equipment recommended for disassembly
and reassembly of V360 telephones. Use either the listed items or equivalents.
Table 1. General Test Equipment and Tools
Motorola Part Number
1
Description
Application
RSX4043-A
Torque Driver Used to remove and replace screws
--
#0 Cross Point Screwdriver
Used to remove cross point screws in
the flip assembly
—
Torque Driver Bit T-5 Plus, Apex 440-6IP
Torx Plus or equivalent
Used with torque driver
See Table 7
Rapid Charger
Used to charge battery and to power
device
0180386A82
Antistatic Mat Kit (includes 66-
80387A95 antistatic mat, 66-
80334B36 ground cord, and 42-
80385A59 wrist band)
Provides protection from damage to
device caused by electrostatic
discharge (ESD)
6680388B67
Disassembly tool, plastic with flat and
pointed ends (manual opening tool)
Used during assembly/disassembly of
device
6680388B01
Tweezers, plastic Used during assembly/disassembly
—
Digital Multimeter, HP34401A
2
Used to measure battery voltage
8102430Z04
GSM / DCS Test SIM Used to enable manual test mode
1. To order in North America, contact Motorola Aftermarket and Accessories Division (AAD) at (800) 422-4210 or
FAX (800) 622-6210; Internationally, AAD can be reached by calling (847) 538-8023 or faxing (847) 576-3023.
2. Not available from Motorola. To order, contact Hewlett Packard at (800) 452-4844.
1 and 2
V360
6809493A69-O
To Next Page
Loading...
