6809493A69-O May 18, 2005 27
Level 1 and 2 Service Manual Disassembly
Removing and Replacing the Transceiver Board Assembly
1. Remove the battery cover, battery, SIM, antenna cap, and rear housing as
described in the procedures
.
2. Use the disassembly tool to unseat the display flex connector from its socket
(see Figure 8).
3. To replace, align the transceiver board assembly to the phone.
4. Carefully place the transceiver board assembly into the front housing.
5. To replace, carefully align the flex connector to it’s socket on the transceiver
PC board assembly, then gently press down on the flex connector until properly
seated in its socket.
6. Replace the rear housing, SIM, battery, and battery cover as described in the
procedures.
G
This product contains static-sensitive devices. Use anti-static handling procedures
to prevent electrostatic discharge (ESD) and component damage.
050324o
Figure 8. Removing the Transceiver PC board Assembly
Transceiver PC Board
Assembly
Display Flex
Connector
Disassembly
Tool
To Next Page
Loading...
