Motorola V360 - Removing and Replacing the Display Assembly

6809493A69-O May 18, 2005 31
Level 1 and 2 Service Manual Disassembly
Removing and Replacing the Display Assembly
1. Remove the battery cover, battery, SIM, antenna, rear housing, transceiver
board assembly, flip assembly, and flip assembly bezel as described in the
procedures.
2. Use the Torx driver and a T6 bit to remove the 2 flip screws from the flip
assembly (see Figure 12).
3. Insert the disassembly tool between the display module and the flip housing
and pry the display assembly up from the flip housing (see Figure 13).
4. Carefully lift the flip display assembly out of the flip housing.
050348o
Figure 12. Removing the Flip Assembly Screws
050349o
Figure 13. Removing the Flip Display Assembly
Flip Screw
Flip Screw
Display Assembly
Flip Housing
Disassembly
Tool