Motorola V360 - Removing and Replacing the Rear Housing

24 May 18, 2005 6809493A69-O
Disassembly V360
Removing and Replacing the Rear Housing
1. Remove the battery cover, battery, SIM, and antenna cap as described in the
procedures.
2. Using a Torx driver with a T-6 bit, remove the 4 screws at each corner of the
phone. Retain the screws for reassembly. See Figure 5.
G
This product contains static-sensitive devices. Use anti-static handling procedures
to prevent electrostatic discharge (ESD) and component damage.
G
In addition to 4 screws, the rear housing assembly is fastened with plastic latches.
These are fragile and should be released with care.
050321o
Figure 5. Removing the rear housing screws
Housing Screw
Housing Screw
Housin
g
Screw
Housing Screw