36 May 18, 2005 6809493A69-O
Disassembly V360
Removing and Replacing the Display Module Assembly
1. Remove the battery cover, battery, SIM, rear housing, antenna, transceiver
board assembly, flip assembly cover, and camera assembly, as described in the
procedures.
2. Use the disassembly tool to unseat the display module assembly from the front
housing (see Figure 18)
3. Avoid damage to the flex while carefully removing the display module assembly
from the flip assembly.
4. Carefully lift the display lens away from the flip assembly.
5. To replace, align the display module assembly to the flip assembly.
6. Carefully lower the display module into the flip assembly. Ensure that none of
the display assembly components are damaged.
7. Replace the motor/vibrator flex assembly, camera assembly, flip assembly
bezel, flip assembly, transceiver board, rear housing, antenna cap, SIM,
battery, and battery cover as described in the procedures.
G
The flexible printed cable (FPC) (flex) is easily damaged. Exercise extreme care when
handling.
Figure 18. Display Module Assembly
Display Module
Flip front housing Disassembly
Tool
To Next Page
Loading...
