Motorola WT4070 - Connecting a Scanner; Starting the Wearable Terminal; WT4070;90 Boot up

1 - 14 WT4070/90 Wearable Terminal User Guide
Figure 1-17 Routing RS309 Scanner Cable from Hip to Hand
Connecting a Scanner
The RS309 and RS409 scanners and the RS507 imager can be used with the wearable terminal. See RS309
Scanner on page 3-10 and RS409 Scanner on page 3-8 for procedures for connecting the scanner to the wearable
terminal. Refer to the RS507 Product Reference Guide for procedures for connecting the imager to the wearable
terminal.
Starting the Wearable Terminal
Press the Power button to turn on the wearable terminal. If the wearable terminal does not power on, perform a
cold boot. See Resetting the Wearable Terminal on page 2-17.
WT4070/90 Boot Up
When the WT4070/90 is powered on for the first time the splash screen (Figure 1-18) appears for a short period of
time followed by the Start Up window on non-touch configurations and the calibration screen on touch enabled
configurations.
NOTE When a battery is fully inserted in a wearable terminal for the first time, upon the wearable terminal’s first
power up, the device cold boots and powers on automatically.