NPort 5000 Series User Manual
3. The OpenSSL needs to be configured before executing the “make” command.
NOTE
The <openssl-arm> and <ssl-arm> are the folders that were created in the previous instruction. The
cross-compiler toolchain "arm-linux-gnueabihf-" is used for the Moxa UC-serial computer.
$ cd openssl
$ setarch i386 ./config no-asm no-shared enable-ssl3 enable-ssl3-method
enable-tls1_3 --prefix=<openssl-arm> --openssldir=<ssl-arm> --cross-compile-
prefix=arm-linux-gnueabihf-
4. Next, make and install the OpenSSL:
$ make
$ make install_sw
Finally, the headers and libraries will be constructed in the following hierarchy:
openssl-arm
├── bin
├── include
└── lib
├── engines
├── libcrypto.a
├── libssl.a
└── pkgconfig
The following command is to build npreal2d with secure mode:
$ arm-linux-gnueabihf-gcc -c ${CFLAGS} -DNO_INIT -DSSL_ON -DOPENSSL_NO_KRB5
npreal2d.c -I/home/user/openssl-lib/openssl-arm/include
If polling mode is preferred, change “${CFLAGS}” to “-DOFFLINE_POLLING”.
$ arm-linux-gnueabihf-gcc npreal2d.o -o npreal2d -lssl -lcrypto -ldl -lpthread -
L/home/user/openssl-lib/openssl-arm/lib/ -I/home/user/openssl-lib/openssl-
arm/include
The npreal2d binary will be generated.
NOTE
Only the npreal2d requires OpenSSL library; other binaries should follow Section “Manually build the Real
TTY driver with a cross-compiler”.
NOTE
The secure mode is supported only if the NPort 6000 enables it. Please refer to NPort 6000 Series User
Manual to configure secure mode in the NPort 6000.
To Next Page
Loading...
Need help?
General
