NPort 5000 Series User Manual
Change Password
You can set a password to restrict access to the NPort’s configuration parameters. (The default password for
NPort is moxa.) If a user does not enter the correct password when accessing the NPort through one of the
consoles (e.g., web console), access to the NPort configuration settings will be denied.
Web Interface for the NPort 5100, 5200, IA5000 Series Only
Web Interface for the Overall NPort 5000 Series
ATTENTION
If you forget the NPort’s password, the ONLY way to configure the NPort is by using the hardware reset
button to load the factory defaults. Before you set a password for the first time, it is a good idea to export
the NPort’s complete configuration to a file. Your configuration can then be easily restored if necessary.
To Next Page
Loading...
Need help?
General
