NPort 6000 Series Initial IP Address Configuration
6. Use the arrow keys to move the cursor to IP address. Use the DELETE, BACKSPACE, or SPACE keys to
erase the current IP address; then, type in the new IP address and press ENTER. Note that if you are using
a dynamic IP configuration (BOOTP, SHCP, etc.), you will need to go to the IPv4 Configuration Field (or
IPv6 Configuration Field) and press ENTER to select the appropriate configuration.
7. Press ESC twice to return to previous page. Press Y to confirm the modification.
8. Press ESC to return to previous page.
9. Press A or use the arrow keys to select Save and then press ENTER. Press ENTER again to confirm the
save command.
To Next Page
Loading...
Need help?
General
