Need help?Do you have a question about the Moxa Technologies NPort IA5150A and is the answer not in the manual?
General| Isolation | 1.5 kV |
|---|---|
| Certification | CE, FCC |
| Serial interface type | RS-232/422/485 |
| Serial ports quantity | 1 |
| Ethernet LAN data rates | 10, 100 Mbit/s |
| Ethernet LAN (RJ-45) ports | 2 |
| Supported network protocols | ICMP, IP, TCP, UDP, DHCP, BOOTP, Telnet, Rtelnet, DNS, HTTP, SMTP, SNTP, IGMP |
| Connectivity LEDs | Yes |
| Storage temperature (T-T) | -40 - 85 °C |
| Operating temperature (T-T) | 0 - 60 °C |
| Operating relative humidity (H-H) | 5 - 95 % |
| Input voltage | 12 - 48 V |
| Safety | UL-508 |
Weight and Dimensions| Weight | 475 g |
|---|---|
| Dimensions (WxDxH) | 36 x 105 x 140 mm |
Provides instructions on connecting power, network, and serial devices to the NPort.
Outlines essential rules and cautions for proper and safe wiring of the device.
Details how to connect the 12-48 VDC power supply to the NPort terminal block.
Explains the importance of grounding and how to properly ground the device.
Guides on connecting the NPort to an Ethernet network via its Ethernet port.
Instructions on connecting a serial device using a serial data cable.
Explains how to determine whether to use a Static or Dynamic IP for the NPort.
Details using the ARP command to set up an IP address for the NPort.
Describes how to configure the IP address using the Telnet console.
Explains how to configure the IP address via the RS-232 serial console.
Describes how Real COM Mode enables serial devices to work over TCP/IP using virtual COM drivers.
Details RFC2217 Mode, enabling transparent serial-to-Ethernet connection with COM port control.
Explains TCP Server Mode, where the NPort passively waits for host connections to get serial data.
Describes TCP Client Mode, where the NPort actively establishes TCP connections to a host.
Instructions on accessing the NPort's web interface via a web browser.
Details configuring IP addresses, subnet masks, gateways, and DNS servers.
Configuration for serial port parameters like baud rate, data bits, and parity.
Detailed settings for serial communication parameters such as flow control and interface type.
Instructions on how to update the NPort's firmware.
Resets all NPort settings to their original factory defaults.
Covers using NPort Administrator to configure device settings.
Details accessing and modifying NPort configuration parameters via Administrator.
Guide on using Administrator to upgrade the firmware of NPort devices.
Steps to create a new COM group for multiple serial ports.
To Next Page
