NPort IA5150A/IA5250A Series Web Console Configuration
UDP Mode
Packing length
Setting Factory Default Necessity
0 to 1024 0 Optional
Default = 0, The Delimiter Process will be followed, regardless of the length of the data packet. If the data
length (in bytes) matches the configured value, the data will be forced out. The data length can be configured
for 0 to 1024 bytes. Set to 0 if you do not need to limit the length.
Delimiter 1
Setting Factory Default Necessity
Delimiter 2
Setting Factory Default Necessity
00 to FF None Optional
Once the NPort IA5150A/IA5250A receives both delimiters through its serial port, it immediately packs all data
currently in its buffer and sends it out the NPort IA5150A/IA5250A’s Ethernet port.
ATTENTION
Delimiter 2 is optional. If left blank, then Delimiter 1 alone
trips clearing of the buffer.
If the size of the serial
data received is greater than 1 KB, the NPort IA5150A/IA5250A
will automatically pack the data and send it
to the Ethernet.
However, to use the delimiter function, you must at least enable Delimiter 1
. If Delimiter 1 is
left blank and Delimiter 2 is enabled, the delimiter function will not work properly.
Delimiter process
Setting Factory Default Necessity
Do Nothing,
Delimiter + 1,
Delimiter + 2,
Strip Delimiter
Do Nothing Optional
To Next Page
Loading...
Need help?
General
Weight and Dimensions
