NPort IA5150A/IA5250A Series Web Console Configuration
Telnet console
Setting Factory Default Necessity
Enable or Disable Enable Required
If you disable both the “Web console” and “Telnet console,” you can still use the NPort Administrator to
configure the NPort IA5150A/IA5250A
device servers either locally or remotely over the network. Refer to
Chapter 6 for more details.
Reset button protect
Setting Factory Default Necessity
No or Yes None Optional
NOTE: Select Yes to allow limited use of the Reset Button, this means that the "Reset to default"
button only works within a 60 seconds time frame. I.e., within 60 seconds after booting up, after
which the "Reset to default" button will be automatically disabled and will no longer work.
Network Settings
You must assign a valid IP address to the NPort IA5150A/IA5250A before the NPort can start operating within
your network. Your network system administrator should provide you with an IP address and related settings
for your network. The IP address must be unique within the network (otherwise the NPort IA5150A/IA5250A
will not have a valid connection to the network). First time users may refer to Chapter 3, Initial IP Address
Configuration, for more information.
You can choose from four possible IP Configuration modes—Static, DHCP, DHCP/BOOTP, and BOOTP—
located under the web console screen’s IP configuration drop-down box.
IP configuration
Method Function Definition
Static User definable IP address, Netmask, and Gateway.
DHCP DHCP server assigned IP address, Netmask, Gateway, DNS, and Time Server
DHCP/BOOTP DHCP server assigned IP address, Netmask, Gateway, DNS, and Time Server, or BOOTP
server assigned IP address (if the DHCP server does not respond)
BOOTP BOOTP server assigned IP address
To Next Page
Loading...
Need help?
General
Weight and Dimensions
