UT1811 - 1010 - UK01
Page 16/32
ADJUSTABLE MULTISPINDLE HEADS
4 Safety rules
• The forward movement speed of the tool must be adjusted so that no excessive axial
force is put on the tool, which could cause it to collapse with the consequent hazardous
cast-off of chips of material.
• Check the conditions and state signs of wear on the tool.
• Any anomalies on the head may cause serious damages and reduce significantly the life-
time and precision of the head. When in doubt, always contact MPA.
• The normal temperature of the head while it is working must not tendentiously exceed
60°C. Only during the first 100 hours of use the temperature can increase its maximum
value by about 25%.
To Next Page
Loading...