UT1811 - 1010 - UK01
Page 8/32
ADJUSTABLE MULTISPINDLE HEADS
1 General notes
1-3 Main information
To obtain maximum product yield in time, we recommend complying with the following
notes:
• Ensure to have correctly installed the multispindle head to the machine.
While choosing the connection to the tool machine, verify compatibility with the
declared performances.
The MPA head can be fitted to a tool machine equipped with regulatory accident-
prevention protections and in compliance with Machinery Directive 2006/42/EC.
• Absolutely avoid any improper use of the equipment and work with care and attention.
• Carry out regularly all routine maintenance interventions (see chap. 10).
• Use only original MPA spare parts (see chap. 11).
1-4 Standard references
The MPA head you have purchased is compliant with Machinery Directive 2006/42/EC (ex
98/37/EC).
1-5 Noise level
The MPA head complies with current Standards with regard to noise levels.
The manufacturer of the machine on which the head is fitted must provide the data
concerning the noise levels in the relative manual.
1-6 Packaging
The multispindle head you have purchased is supplied packed in cardboard boxes and
protected with shock-resistant protections.
IMPORTANT Upon receipt, check that the supply corresponds to the order specifications and
that no damages have occourred during the transport. In case of anomalies,
do not use the head and contact the manufacturer immediately.
Packaging must be disposed of in compliance with the local waste disposal Standards.
To Next Page
Loading...