UT1811 - 1010 - UK01
Page 28/32
ADJUSTABLE MULTISPINDLE HEADS
10 Maintenance
IMPORTANT Never apply excess lubricant, as this will cause the hazardous over-heating
of the same head when it is in use.
Only use the type of lubricant indicated on the nameplate.
Personnel required: Technician
• About every 12 months:
It is advisable to take the head off to visually inspect the Kinematic devices, to check the
wear of the bearings and the seals, and to replace any worn components. Replace the old
lubricant with fresh lubricant of the same type as indicated on the nameplate, filling the
spaces to be lubricated by about 1/3 of their volume.
When this operation has been completed, check if the head works efficiently and make
sure that there are no leaks of lubricant.
ADJUSTMENT For this intervention and/or any other not mentioned above, it is advisable
to contact MPA srl directly.
To Next Page
Loading...