GB
Safety Regulations
8
1.3 Safety and Precautionary Measures to be Adopted
Carefully review the following safety limitations and precautions before placing
this device in service:
(1) Perform the following check before each day’s use to verify proper device
operation:
Check pump for proper operations (see chapter 3.1). Have pump serv-
iced if necessary.
(2) Keep the probe tip above liquid surfaces; otherwise, liquid may enter the
system and block sample flow, causing internal damage.
(3) Charge device in non-hazardous areas only.
(4) Do not alter this device or make any repairs beyond those specificed in this
manual. Only MSA-authorized personnel may repair this unit; otherwise
damage may result.
Filter Maintenance
Visually examine the external dust and water filter before each use. Replace
filter with a new one if it is dirty.
Be Aware of Environmental Conditions
A number of environmental factors such as temperature and humidity may
affect the flow rate, run time and charge time.
Be Aware of the Procedures for Handling Electrostatically Sensitive
Electronics
The device contains electrostatically sensitive components. Do not open or
repair the device without using appropriate electrostatic discharge [ESD]
protection. The warranty does not cover damage caused by electrostatic
discharges.
Be Aware of the Product Regulations
Follow all relevant national regulations applicable in the country of use.
Be Aware of the Warranty Regulations
The warranties made by Mine Safety Appliances Company with respect to the
product are voided if the product is not used and maintained in accordance with
the instructions in this manual. Please protect yourself and others by following
them. We encourage our customers to write or call regarding this equipment
prior to use or for any additional information relative to use or service.
FASIT Srl - Via Orsera 13/b - 34145 TRIESTE - ITALY - Tel +39 040 825604 - www.fasit.it - info@fasit.it
To Next Page
Loading...