GB
Maintenance
18
4 Maintenance
4.1 Cleaning and Periodic Checks
As with all electronic equipment, the ALTAIR Pump Probe will operate only if it
is properly maintained.
4.2 Cleaning and Routine Care
Periodically clean the ALTAIR Pump Probe case with a soft damp cloth.
4.3 Checking The Pump Inlet Filter
The ALTAIR Pump Probe contains a filtering system to protect the pump from
particulate and water in the sample air. If the filter becomes clogged, the sample
flow may be blocked, or an extra load may be placed on the pump. Visually
check the filter regularly. The frequency of checks should depend on amount of
pump usage and concentration of particles that enter the pump.
WARNING
Repair or alteration of the ALTAIR Pump Probe, beyond the procedures
described in this manual or by anyone other than a person authorized by MSA,
could cause the device to fail to perform properly. Use only genuine MSA
replacement parts when performing any maintenance procedures described in
this manual.
Substitution of components can seriously impair device performance, alter
intrinsic safety characteristics or void agency approvals.
FAILURE TO FOLLOW THIS WARNING CAN RESULT IN SERIOUS
PERSONAL INJURY OR DEATH.
FASIT Srl - Via Orsera 13/b - 34145 TRIESTE - ITALY - Tel +39 040 825604 - www.fasit.it - info@fasit.it
To Next Page
Loading...