Contents
1 About the MSA FieldServer ProtoNode 5
1.1 Certification 5
2 Equipment Setup 6
2.1 Mounting 6
2.2 Physical Dimensions 7
2.2.1 Serial-Ethernet ProtoNode Drawing 7
2.2.2 LonWorks ProtoNode Drawing 8
3 BACnet/LonWorks Setup through ProtoNode 9
3.1 Features 9
3.2 Installation Steps for the Customer 9
3.3 Record Identification Data 9
3.4 Configure the DIP Switches 10
3.4.1 Setting the Node/ID Device Instance (DIP Switch A0 ā A7) 10
3.4.2 Setting the Serial Baud Rate (DIP Switch B0 ā B3) 10
3.4.3 Select and Load Configuration Files 11
4 Interfacing ProtoNode to Host OEM Device 12
4.1 ProtoNode FPC-N34 and FPC-N35 Showing Connection Ports 12
4.2 Device Connections to ProtoNode 13
4.2.1 RS-485 / RS-232 13
4.2.2 KNX 14
4.2.3 M-Bus 14
4.3 Resistor and Power Jumper Information 15
4.3.1 Bias Resistors 15
4.3.2 Termination Resistor 16
4.3.3 Power Jumper Settings 16
4.4 Wiring Field Port to RS-485 BMS Network 17
4.5 Wiring Field Port to a LonWorks Network 17
5 Power up the ProtoNode 18
6 Connect the PC to the Gateway 19
6.1 Connecting to the Gateway via Ethernet 19
6.1.1 Changing the Subnet of the Connected PC 19
6.2 Navigate to the Login Page 19
7 Setup Web Server Security 20
7.1 Login to the FieldServer 20
7.2 Select the Security Mode 22
7.2.1 HTTPS with Own Trusted TLS Certificate 23
7.2.2 HTTPS with Default Untrusted Self-Signed TLS Certificate or HTTP with Built-in Payload Encryption 23
8 Configure the FieldServer 24
8.1 Setting IP Address for Field Network 24
8.1.1 Accessing the FieldServer Manager 25
9 Commissioning the ProtoNode on a LonWorks Network 26
3 ProtoNode Start-up Guide
To Next Page
Loading...
