MSA FS-ROUTER-BAC2 - Network Setup; 7.1 Ethernet 1 Settings

7 Setup Network
7.1 Ethernet 1
To change the IP Settings, follow these instructions:
• Enable DHCP to automatically assign IP Settings or modify the IP Settings manually as needed, via these fields: IP
Address, Netmask, Default Gateway, and Domain Name Server1/2.
NOTE:If the FieldServer is connected to a router, the IP Gateway of the FieldServer should be set to the same
IP Address of the router.
• Click Save to record and activate the new IP Address.
• Connect the FieldServer to the local network or router.
NOTE:If the FS-GUI was open in a browser, the browser will need to be pointed to the new IP Address of the
FieldServer before the FS-GUI will be accessible again.
16 BACnet Router Start-up Guide