16
Maintenance and Care
G1
US
2.11 Removing the Valve Assembly
(8) Install two (2) new 8 mm O-rings to the electrical plug.
(9) Install the regulator. (See Installing the G1 Regulator
Hose Assembly for instructions.)
(1) Remove the regulator (See Removing the G1 Regulator for instructions).
(2) Remove the diaphragm (See Removing the Diaphragm for instructions).
(3) Push the regulator housing buttons to ensure the valve
fork is set in the raised position.
(4) Carefully lift the valve assembly out of the housing.
To Next Page
Loading...
