MSI H67MS-E33 series - Hardware Monitoring

3-18
BIOS Setup
MS-7680
Chapter 3
BIOS Setup
MS-7680
Chapter 3
H/W Montor
Press <Enter> to enter the sub-menu.
CPU Smart Fan Target
The Smart Fan functon controls the CPU fan speed automatcally dependng on the
current temperature to keep t wth n a spec󰘰c range. You can enable a fan target
value here. If the current CPU fan temperature reaches to the target value, the smart
fan functon wll be actvated.
CPU Mn.Fan Speed(%)
Ths tem allows users to select how percentage of mnmum speed lmt for the CPU
fan.
SYS Fan 1 Control
Ths tem allows users to select how percentage of speed for the SYSFAN1.
CPU/ System Temperature, CPU FAN/ SYS FAN 1/ 2 Speed, CPU Vcore, CPU IO,
DRAM Voltage, GPU Voltage, 3.3V, 5V, 12V
These tems show the current status of all of the montored hardware devces/com
-
ponents such as CPU voltage, temperatures and all fans’ speeds.
Power Management Setup
Press <Enter> to enter the sub-menu.
EuP 2010
Ths tem s desgned for Energy Usng Products Lot 6 2010 (EuP) aka Energy Re
-
lated Products (ErP). To reduce Power Consumpton when system o󰘯 or standby
mode.
Note: When “Enable” EuP 2010, system doesn’t support RTC wake up event func-
ton.
Restore on AC Power Loss
Ths tem spec󰘰es whether your system wll reboot after a power falure or nterrupt
occurs. Settngs are:
[Power O󰘯] Always leaves the computer n the power o󰘯 state.
[Power On] Always leaves the computer n the power on state.
[Last State] Restore the system to the status before power falure or nterrupt
occurred.
▶
▶
▶
▶
▶
▶
▶
▶