3-19
BIOS Setup
Port IRQ
When OnBoard Parallel Port is set to Auto, the item shows Auto indicating that BIOS
determines the IRQ for the parallel port automatically.
Port DMA
This feature needs to be configured only when Parallel Port Mode is set to the ECP
mode. When Parallel Port is set to Auto, the field will show Auto indicating that BIOS
automatically determines the DMA channel for the parallel port.
VT8237 PATA-IDE Controller
This setting is used to enable/disabled the VT8237 PATA-IDE controller. Setting options:
Enabled, Disabled.
VT8237 SATA-IDE Controller
This setting is used to enable/disabled the VT8237 SATA-IDE controller. Setting options:
Disabled, Enabled.
V-Link Data 2X Support
This setting controls the onboard V-Link Data 2X Support. Setting options: Enabled,
Disabled.
OnBoard LAN, OnBoard LAN P.M.E.
This is used to enable or disable the onboard LAN controller and the wake-on-LAN
function. Setting options: Enabled, Disabled.
Onboard 1394, Onboard S.ATA, OnBoard AC’97 Audio
Set these options to Enabled to enable the controllers of these 3 PCI devices.
USB Controller
This setting is used to enable/disable the onboard USB ports. Setting options: Disabled,
2 USB Ports, 4 USB Ports, 6 USB Ports, 8 USB Ports.
USB Device Legacy Support
Set to All Device if you need to use any USB device in the operating system that does
not support or have any USB driver installed, such as DOS and SCO Unix. Set to No
Mice only if you want to use any USB device other than the USB mouse.
USB 1.1 Port 64/60 Emulation
This field allows you to enable or disable the USB Port 64/60 Emulation function.
When the function is enabled, the USB keyboard is allowed to type some special
combination keys.
To Next Page
Loading...
