MSI K8MM-ILSR

3-18
MS-6741 Micro-ATX Mainboard
Integrated Peripherals
Floopy Disk Controller
This is used to enable or disable the onboard Floppy controller.
Serial Port 1
This item specifies the base I/O port addresses of the onboard Serial Port 1 (COM A).
Selecting Auto allows AMIBIOS to automatically determine the correct base I/O port
address. Settings: Auto, 3F8/COM1, 2F8/COM2, 3E8/COM3, 2E8/COM4 and
Disabled.
Parallel Port
This field specifies the base I/O port address of the onboard parallel port. Selecting
Auto allows AMIBIOS to automatically determine the correct base I/O port address.
Settings: Auto, 378, 278, 3BC, Disabled.
Port Mode
This item selects the operation mode for the onboard parallel port: ECP, Normal, Bi-
Dir or EPP.
EPP Version
The item selects the EPP version used by the parallel port if the port is set to EPP
mode. Settings: 1.7, 1.9.
Option Description
Auto BIOS will automatically determine whether to enable the onboard
Floppy controller or not.
Enabled Enables the onboard Floppy controller.
Disabled Disables the onboard Floppy controller.