mspa Lite Bubble Spa - How to Replace the Bubble Generator

2016 MSpa Service Manual
MSpa website: www.the-mspa.com
- 15 -
7. Tak e o u t t h e p o we r b oa rd c a se
8. Take out the power board from the case
9. Disconnect all electrical cables and detection leads from the original power board and connect all cables to the
new power board correctly and assemble the power board into the control box in reverse order.
4.5 How to Replace the Bubble generator
1. Take off water inlet and outlet caps
2. Remove the control panel
3. Deflate spa pool
4. Unscrew the check valve plastic nut
The$upper$square$valve$is$for$inflation$
The$button$round$valve$is$for$deflation$