19
16.7. Inspect the bracket for wear or damage. Pay
close attention to the notched teeth on the
bracket. See Figure 64.
16.8. Assemble in reverse order of disassembly
17. SPEED CONTROL LATCH REMOVAL
17.1. Remove the cutting deck.
17.2. Remove the cotter pin securing the speed con-
trol selector rod to the speed control latch. Slide
the ferrule from the latch. See Figure 65.
NOTE: Mark the position of the ferrule on the rod
with some whiteout. This will aid assembly and
allow you to maintain the proper position of the
ferrule.
Figure 64
Figure 65
Speed Control Selector Rod
Cotter Pin
White Out
17.3. Using a 9/16” socket and an open-end wrench,
remove the nut securing the speed control latch
assembly to the frame. See Figure 66.
17.4. Inspect the latch for any wear or damage. Pay
close attention to the flange that mates with the
Figure 66
Locking Hex Flange Nut
Figure 67
View of latch assembly from under the unit.
www.mymowerparts.com
For Discount White Outdoor Parts Call 606-678-9623 or 606-561-4983
To Next Page
Loading...
