Chapter 4: The Fuel System and Governor
49
4. Slide the gear shaft out of the gear and cup.
See Figure 4.60.
5. Install by following the above steps in reverse
order.
NOTE: Check the governor arm for freedom of
movement before test running the engine.
6. Test run the engine and adjust the top no load
engine rpms by following the steps described in
“Disassembly and rebuilding the carburetor” sec-
tion of this chapter.
References
1. Dr. Ullmann, J, Fuels, Automotive Handbook,
seventh edition. Bosch, Robert distributed by
SAE Society of Automotive Engineers, 2007.
320.
Figure 4.60
Governor gear
Governor cup
Gear shaft
Governor cup washer
www.mymowerparts.com
For Discount White Outdoor Parts Call 606-678-9623 or 606-561-4983
To Next Page
Loading...
Need help?
General
