System Clock
The system clock time base selection is displayed. The system clock uses the power line
frequency as a time base. The clock time base selection must match the power line fre-
quency as supplied to the monitor. Press the mode key to change the clock time base
selection. Available selections are 50 or 60 hertz.
The current system clock time is displayed. To change the time setting press the MODE
key and enter the desired month, day, year, hour (24 hour clock), minutes, and seconds.
THE CURRENT TIME IS:
6-15-95 10:29:42
‘Mode’ TO CHANGE
‘Enter’ TO CONTINUE
NOTE
After changing the clock time base, the power must be
temporarily removed from the Level Plus monitor to
activate the new selection. This can be done by
cycling the on/off switch located behind the front
cover (at the end of the programming session).
CLOCK LINE FREQUENCY
60 HERTZ
‘Mode’ TO CHANGE
‘Enter’ TO CONTINUE
NOTE
The display update time setting does not affect the
tank gauge scan rate or output updates.
DISPLAY UPDATE TIME =
--- SEC (1-25)
‘Enter’ NEW VALUE
37
To Next Page
Loading...
Need help?
General