The Analog Output Card has a 15 pin edge card connector, the function of each pin is as follows:
Table 12A
Analog Output Card Pin Identification
Pin No. Function
1 DC Ground (Current return for grounded systems)
2 +5 Vdc input (optional)
3 - 15 Vdc input
4 +12 Vdc to transducer (for strokes < 180 in.)
5 +15 Vdc input (+24 Vdc is optional)
6 +15 Vdc to transducer (for strokes ³ 180 in.)
7 External reference input (optional)
8 -15 Vdc to transducer
9 + Pulse width modulated signal (optional)
10 Dependent upon unit configuration. Options include:
• 4-20 mA ungrounded velocity return, or
• Channel 2 return for dual channel displacement
11 Dependent upon unit configuration. Options include:
• Velocity output (current source), or
• Channel 2 output for dual channel displacement
12 Analog displacement output (current source)
13 Displacement return for 4-20 mA ungrounded output systems
14 Output pulse
15 + Interrogation pulse to transducer
NOTE:
The mating edge connector is MTS p/n 370034, and may be ordered by contacting the factory.
The connections from the Temposonics II transducer to the Analog Output Card are as follows:
Table 12B
Temposonics II Connection to Analog Output Card
Temposonics II Integrated or Extension Cable (see Note 1)
Pin No. Wire Color Code Wire Color Code Analog Output Card Pin No.
1 White/Blue Stripe White 1
2 Blue/White Stripe Brown 1
5 White/Green Stripe Red 4
6 Green/White Stripe Blue 8
7 White/Brown Stripe Black 1
8 Brown/White Stripe Violet 14
9 White/Gray Stripe Yellow 15
10 Gray/White Stripe Green 1
NOTES:
1. Verify if the cable has striped or solid color leads and make connections accordingly.
2. Shield wire (drain) can be connected to Pin 1 on the Analog Output Card.
37
To Next Page
Loading...