Installation
Mounting the terminal in the vehicle cab
1. Screw the terminal plate onto the rear of the terminal: Always use all four screws supplied.
2. Unscrew the long bolt out of the pipe bracket:
3. Attach the two bracket components together:
4. Insert the long bolt through the assembled bracket:
5. Screw in the long bolt until the terminal is firmly attached.
⇨ You can now attach the terminal with the bracket on a round pipe (e.g. on the ME mounting
bracket).
Connecting the terminal to the ISOBUS
When it is connected to the ISOBUS, the terminal is supplied with voltage and communication is
possible with other ISOBUS components.
1. Connect the connector cable to the basic vehicle harness or the ISOBUS In-Cab-Connector.
2. Screw in the connector tightly.
To Next Page
Loading...
Need help?
General
