⇨ You have connected the terminal to the ISOBUS.
Connecting sensors to the terminal
The terminal can receive signals from the following sensors:
▪ Work position sensor
Purpose:
– Display of the work position on the start screen.
– Transmission of the signal received through the signal socket to the ISOBUS.
Possible signal sources:
– 7-pin signal socket on the sensor connection of the terminal.
– An ISOBUS job computer.
▪ Speed sensor
Purpose:
– Display of the speed on the start screen.
– Transmission of the signal received through the signal socket to the ISOBUS.
Possible signal sources:
– 7-pin signal socket on the sensor connection of the terminal.
To Next Page
Loading...
Need help?
General
