Multiplex MS-8-1H User Manual

For factory assistance, call
888-436-5442
Fax 888-779-2040
Multiplex
Page 17
Clean Blended Ice Machine (BIM-8) (continued)
©McDonald’s Corporation · Planned Maintenance Manual · July 2009 Page 4 of 4
Blended Ice Machine Model MS-8-1H
Weekly
BE 23 W1
31
Spray interior of ice bin with
Sanitizer Solution.
Allow to air dry.
Use caution when wiping near
the shaver blade.
SolidSense Sanitizer
32
Replace ice bin lid.
33
Slowly pour two full pitchers of
hot water into the rinser sink
area.
34
Pull out the pressure relief
knob on the BIO-SHIELD®
dispenser.
35
Remove the cap from the BIO-
SHIELD® dispenser.
36
Pour two full pitchers of hot
water into the dispenser.
37
Quickly pour one packet of
BIO-SHIELD Tower Drain
Cleaner into the dispenser.
Immediately replace and
tighten the cap. Shake the
dispenser to dissolve the
cleaner.
Drain Cleaner.
38
Carefully purge a small
amount of solution from the
dispenser into the utility sink.
This helps prevent
“sputtering” of solution and
possible splashing back onto
clothing or eyes.
39
Carefully spray the solution
into the rinser sink drain hole.
40
Pull out the pressure relief
knob on the BIO-SHIELD®
dispenser.
41
Remove the cap from the BIO-
SHIELD® dispenser.
42
Rinse the BIO-SHIELD®
dispenser.
Rinse the BIO-SHIELD®
dispenser with warm water
and return the dispenser to the
proper storage area.
IMPORTANT! Do not use
the drain for at least four
hours after cleaning.
43
Perform a Daily Cleaning
procedure.
See XX 00 D1 for procedure.
Sharp Objects/Surfaces

Multiplex MS-8-1H Specifications

General

Brand	Multiplex
Model	MS-8-1H
Category	Ice Maker
Language	English