For factory assistance, call
888-436-5442
Fax 888-779-2040
Page 16
Clean Blended Ice Machine (BIM-8) (continued)
©McDonald’s Corporation · Planned Maintenance Manual · July 2009 Page 3 of 4
Blended Ice Machine Model MS-8-1H
Clean drain pan.
Pull the bottom drain pan
from inside the machine.
Take to 3-compartment sink
and wash, rinse and sanitize.
SolidSense APSC, SolidSense
Sanitizer
Reconnect product holders
and bags.
Retrieve product bags from
walk-in cooler and install
them into the product
containers. Then install each
container into its proper
location.
Replace cleaning pitcher with
blending pitcher.
Press Next.
The message window will
display: “Auto prime of
product lines”.
Place discharged product in
trash or back sink.
Remove and clean ice bin lid.
Take ice bin lid to 3-
compartment sink. Wash,
rinse and sanitize. Allow to
air dry.
SolidSense APSC
SolidSense Sanitizer
Empty ice bin.
Use an ice scoop and an
empty bucket to remove as
much ice as possible from
above the ice shelf.
Place a blend pitcher on the
pitcher pad.
Melt away remaining ice.
From a blend pitcher, pour
warm water in a circular
motion into the ice bin and
allow to drain into pitcher.
Empty pitcher in the drain area
and return to pitcher pad.
Fill pitcher with SolidSense
APSC.
Fill a blend pitcher with
SolidSense APSC.
SolidSense APSC
Pour in SolidSense APSC.
Slowly pour the SolidSense
APSC into the ice bin in a
circular motion, as close to
and as high up the inside
walls as possible, without
splashing solution outside the
unit.
Tip
Some of the cleaning solution
will dispense out of the area
above and behind the pitcher
pad. This is normal.
Use clean sanitizer-soaked
towel to clean inside of
hopper.
Use caution when wiping near
the shaver blade.
Rinse ice bin with clean water.
Fill a blend pitcher with clean
water. Slowly pour the water
into the ice bin in a circular
motion, as close to and as
high up the inside walls as
possible, without splashing
outside the unit. Repeat if
needed for a thorough rinse.
To Next Page
Loading...
General