MULTIQUIP WHITEMAN MD105 - Maintenance - Daily Lubrication; Spider Lubrication Procedure (Daily); Thrust Collars Lubrication Procedure (Daily)

MD105 RIDE-ON TROWEL • OPERATION MANUAL — REV. #0 (03/29/24) — PAGE 39
Thrust Collars (Daily)
Perform the following lubrication procedure after every
8 hours of operation.
1. Locate the Zerk grease tting on either thrust collar
(Figure 38). Remove the Zerk tting cap and set it
aside.
Figure 38. Thrust Collar Lubrication
2. Wipe the Zerk grease tting clean to prevent abrasive
material from entering the tting during lubrication.
3. Lubricate the Zerk grease tting with one shot of
multipurpose grade grease. Replace the Zerk grease
tting cap when nished.
4. Repeat steps 1–3 for the grease tting on the remaining
thrust collar.
ZERK
FITTING CAP
THRUST
COLLAR
ZERK GREASE
FITTING
MAINTENANCE
Spiders (Daily)
Perform the following lubrication procedure after every
8 hours of operation.
1. Locate one of the Zerk grease ttings on either spider
assembly (Figure 37). Remove the Zerk tting cap
and set it aside.
Figure 37. Spider Lubrication
2. Wipe the Zerk grease tting clean to prevent abrasive
material from entering the tting during lubrication.
3. Lubricate the Zerk grease tting with 1–1½ shots of
multipurpose grade grease. Replace the Zerk grease
tting cap when nished.
4. Repeat steps 1–3 for the remaining grease ttings (total
of 12) on both spider assemblies.
ZERK
FITTING CAP
SPIDER
ASSEMBLY
ZERK GREASE
FITTING