MULTISPAN PTC-1202A - Parameter Setting Procedures; Analog Output and Controlling Setup; Password and Basic Configuration

PARAMETER SETTING
ALM1=IN-B,AB-O,OT-B
ALM1=IN-B,AB-O,OT-B
Press key
Press key
Press key
SET
S2MD = INDI
S2MD = INDI
ALM2=IN-B,AB-O,OT-B
ALM2=IN-B,AB-O,OT-B
S1MD = INDI
Process Value
Set Value
S1MD = INDI
SET
SET
Analog O/P = Controlling
/
Analog O/P = Controlling
Password 73 Explanation
RLY 1 / RLY 2
/A.OUT/SOAK/M.BUS
If Auto Mode
Note : In case 4 & 8 relay will be in off condition
If Manual Mode
/
/
/
Parameter 1 : Basic Configuration ( )
Parameter 2 : Relay 1 ( )
Case 1 : Heat
Case 5 : Heat
Case 2 : Cool
Case 6 : Cool
Case 3 : Alarm
Case 7 : Alarm
Case 4 : Off
Case 8 : Off
Parameter 3 : Relay 2 ( )
Parameter 5 : Soak Timer( )
Parameter 4 : Analog Output ( )
To set Controlling Output Mode press key
SET
+
Case 4 & 8 : OFF