RPR 950 Series
Combinations of alert options are possible, including
visual only, sound and visual, or any option and vibrate.
The audible/visual option allows you to get an out of
range warning on the display for 4 seconds and a buzzing
sound for 2 seconds.
Pagers with audible alerts enabled will also buzz if the OCR
button is pressed while the receiver is out of range (except
in mute mode). For the visual alert only, only the message is
displayed. In any case, if selected, the vibrate option
causes several short pulses during the alert period.
You can program your pager and get the following other
options:
After the 4 second alert period, the pager continues to
display the Out of Range message or if a received
message is logged, it is shown until cleared.
Group Alert - Your pager can be programmed to work
as part of a 'team'. Any group call to your team will activate
an audible alert sequence, even if your pager is set to
mute.
Low Battery Warning - It is not recommended to enable this
option when using rechargeable cells.
Out of Range - This option tells you that you are in an area
that is out of radio coverage. The alert activates if the pager
has not received a valid signal for a predetermined time,
typically 3 minutes and 30 seconds.
Your pager's battery status is constantly
monitored and if low battery voltage is detected,
the pager will continue to operate but the battery
should be replaced as soon as possible (within 24
9261 – 9629 Issue 2 16
13. OTHER OPTIONS
Machine Translated by Google
To Next Page
Loading...