RPR 950 Series
14. BATTERIES - Battery Replacement and Battery
Maintenance
17
9261 – 9629 Issue 2
hours) otherwise, operation cannot be guaranteed and
some features will not work.
(iii) the status of the battery can be checked at any
time, using the status query mode as described in
section 11. The low battery message
is displayed and the pager returns to standby mode, the
message bat continues to display at the edge of the display.
You can use your pager with any 1.5 Volt nominal AA (LR6)
primary cell, or for rechargeable battery uses, NiCD (if
permitted) or NiMH secondary cells. You should
be aware that the expected battery life can vary widely
depending on the
Once enabled, this option can be programmed for visual,
audible and vibrate alert options. A warning is activated
under the following conditions:
Call Comparator - This option allows the pager to
recognize calls that are a repeat of a previous call, sent
within a preset time after the original call. The pager can
ignore repeated calls identified by the comparator. The time
limit can be programmed for durations of 30 seconds, 120
seconds and 300 seconds after the original call.
(i) during ignition - the ignition signal may be modulated
by a buzzing sound and the low battery message
is displayed;
This does not apply to message calls if the original call
was not decoded as a 100% confident match. In this case,
the next call will be accepted and will overwrite the original
message in the pager's memory. In both cases, however, a
normal alert sequence will be generated.
(ii) all alerts are modulated by a buzzing
sound;
Machine Translated by Google
To Next Page
Loading...