RPR 950 Series
Your pager was designed to provide you with status
information on demand. To activate this feature, press the
OCR button once while the pager is in sleep mode. This results
in the display of the message status>, it is automatically
followed by each programmable status message as
follows:
*Battery low low.
One or more new
State
No other message
Your pager has not received
a valid system signal for at
least 3.5 minutes.
Walk
Out of reach
*Vibrator
*
Vibrate option selected
2 new posts
The pager is in mute mode.
1 new post posts
*Mute
The battery voltage is
*Note: For this option to work, your pager must be
programmed to display this message.
Status message
Depending on your pager
options, refer to section 12.
*Hour
to display
9261 – 9629 Issue 2
14
11. PAGER STATUS
Machine Translated by Google
To Next Page
Loading...
