Page
14
of
18
IMC01 Frequently Asked Questions
Version 1.05
2) If there is still some error happen, please calibrate the CIS with the calibration white paper.
3) If you meet some chain note (the feeding gap is too large) or half note error (the feeding gap is too small),
please readjust the feeding gap by rotating the screw according to section 2.6.
4) If you meet some UV, MT, MG or IR errors, please check the bill first, or decrease the CFD level and try
again.
5) If it still doesn’t work you try the above steps, go to the “Service Menu->Back to Default Setting” to reset
your changed settings.
2.10. How can I turn off the key beep
？
You can follow the steps below to turn off the key beep:
1) Enter the main menu, and go to the service menu with the password “9999”, as shown in the following
screenshots.
Figure 2-24 Menu and Service Menu
2) choose “④Function Setting” and press enter. You will see the following.
Figure 2-25 Function Setting Interface
3) Press key beep to toggle this setting.
Figure 2-26 Menu and Service Menu
2.11. What should I do if my preset batching is not working correctly?
If the banknote counter does not stop at the correct preset batch quantity, please reset the banknote counter
according to section 2.8.
To Next Page
Loading...
