Muncie ADVANTAGE + - PLOW ANGLE ISSUES; HOIST ISSUES

28
ADVANTAGE PLUS SYSTEM TROUBLESHOOTING
PLOW ANGLE ISSUES
ISSUE POTENTIAL PROBLEMS
Plow Does Not Angle (left or right) Check the plow angle speeds in the controller
Check the electrical circuit for opens and shorts (Look for error messages)
Check crossover relief “on Plow”
Check to see if quick disconnects are seated properly
Check to see if quick disconnect manifold is held open (debris)
Check EHPR1 (Plow Right Pilot) or EHPR2 (Plow Left Pilot)
Check PE2 fo Contamination
Check CV4 or CV5 for contamination
Do the cylinder panel buttons change from green to red - If not, check the harness
Sync Truck Prole
Plow Angles Slow
Check the Controller Speed Settings
Make sure plumbing is not restricting ow
Is Pump Undersized (need more displacement)
Check Boost Pressure Setting
Sync Truck Prole
HOIST ISSUES
ISSUE POTENTIAL PROBLEMS
Hoist Does Not Raise Check the Controller Speed Settings
Check the Hoist Down Manual Override (SP5 or Additional SP)
Check the Hoist Down Flow Control for Contamination (SP5 or additonal SP)
Check the Plumbing (are the HA and HB ports plumbed backwards)
Check the Hoist up Relief for Contamination (RV4)
Check if the Plow Cylinder is leaking internally
Hoist Raises, but drifts down slowly
Check the ow control for contamination (SP5 or Additional SP)
Check the hoist upside relief (RV4) for contamination
Check the load holding check valve for contamination (CV6)
Hoist Raises Slowly
Check the Controllers Speed Settings
Check the pump displacement - May need larger displacement pump
Check Boost Pressure Relief Setting - Should be set at 200 PSI
SA Telescopic Hoist Lowers Slowly
Did we check the controller speed settings
Verify that hoist isolation plug is installed? Is T2 routed directly to the Reservoir
Did we install a second SP16 in the CP2 cavity to lower the hoist
Hoist Slams Down When Lowering
Turn the Hoist Max Speeds Down on the controller