EasyManua.ls Logo

Munters MK30D - 4 Maintenance and Service; Monthly Preventive Maintenance (MK30 D-MK60 D); Monthly Preventive Maintenance (MK90 D)

Munters MK30D
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Dehumidier M KD-series
4 MaintenanceandService
The unit includes mechanical and electrical parts and the unit is often placed in a rough environment where
the com ponents are exposed to different climate conditions. Therefore the unit will need preventive
maintenance on a regular basis.
Proper maintenance of the unit is necessary in order to achieve trouble-free operation. This section contains
description of the recommended monthly and annual maintenance.
CAUTION!
Alwaysdisconnectthepowerc
ablefromtheunitbeforedoinganypreventivemaintenance!
4.1 Monthlypreventivemaintenance(MK30D-MK60D)
Follow this procedure to car ry out the monthly preventive maintenance:
1 Open the front grill by tilting it outwards
2Removethelter. Either rinse it with lukewarm soapy water or vacuumclean it if the lter is only
a little dirty. Change the lter if it is ver y dirty.
3 Clean the water tank
4 Remove the two screws in each side and tilt the jacket outwards about 30º
5 Lift t he jacket up and clear of the dehumidier
6 Clean the evaporator coil by brushing with a soft brush and vacuum-clean/compressed air. Mount
the jacket and put the water tank back in place Note! Check that the water tank is tted correctly
4.2 Monthlypr
eventivemaintenance(MK90D)
Follow this procedure to car ry out the monthly preventive maintenance:
1 Open the front grill by tilting it outwards
2Removethelter. Either rinse it with lukewarm soapy water or vacuum clean it if the lter is only a
little dirty. Change the lter if it is very dir ty
3CleanthedriptrayNote !When you ret the drip tray, make sure that the back edge of the drip tray
rests on the edg e inside the dehumidier.
4 Remove the two screws in each side and tilt the jacket outwards about 30°
5 Lift the jacket up and clear of the dehumidier
6 Clean the evaporator coil by brushing with a soft brush and vacuum-clean/compressed air
7 Mount the jacket
17 MaintenanceandService 190TEN-1071-C1304

Related product manuals