EasyManua.ls Logo

Munters MK30D - 5 Trouble Shooting

Munters MK30D
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Dehumidier M KD-series
5 Troubles hooting
Use the table below to localise and co
rrect problems or errors:
Problem Possible Cause Action
Dehumidier will not start
Display not switched on
Plug not in mains socket Check dehumidier is connecte
d
to the mains. Check the mains
socket if necessary by connec
ting
another electrical applianc
e
The hygrostat has m easured
air humidity lower than th
eset
point, and switched off t
osave
power
Reduce hygrostat set point
,or
switch to manual operatio
n. See
the section on Internal h
ygrostat
operation, chapter.3.3
.
Dehumidier will not start
Green light not on
HYG STOP shown on
display
Room temperature is be
low
Candthedehumidi
er
is automatically pu
toutof
operation
Wait for the te mperatu
re to rise
above 3 °C
Yellow light on display shows
Full
Container full or pump
(accessory) blocked
Empty water container or clear
pump blockage
Dehumidier running
Green light on
SERVICE ashing on
display
Service interval set has expired Service the product as specied
in the section on serv ice counter
expir y
Dehumidier running
When RH% activates, the
display shows SENSOR
FAIL
RH% sensor defective Replace RH% sensor
kWh and hours without
power not displahyed
Memory battery at Replace battery. See chapter 3.8
NOTE!
Ifthemachineisnotworkingproperly, switchoffimmediately!
•Befo
restartingtroubleshooting,waitforone minute,astheelectronicscouldhave cutoff themachineforsafety
reaso
nsy
If the dehumidier will not restart, contact Munters. This also applies if the machine runs without
condensing any water. There may be a fault on the cooling circuit which will require a service technician
19 Troubleshooting 190TEN-1071-C1304

Related product manuals