Munters MK30D - 1 Introduction; General; Unpacking of the Units MK30 D-MK60 D; Unpacking of the Unit (MK90 D)

Dehumidifier M KD-series
1Introduction
1.1 General
The Munters MKD-series dehumidifi
ers are available in four (4) different sizes and they can easily be moved
to locations where dehumidificati
on of air is required.
WARNING!
Itisthe resp onsibilityoftheoperatortorea d and understandthisservice manual and othe r inform ationprovided,
andto usethecorrectoperatingprocedures.
Read the entire manual before the initial start-up of the dehumidifier. Awareness of the correct operating
procedure for the machine and its safety devices is important, to avoid damage or injury.
1.2 UnpackingoftheunitsMK30D-MK60D
WARNING!
Ifthedehumidifierha
sbeen laiddown duringtransport,itis imperativethatyouplaceitinuprightpositionforat
least1hourbeforepu
tintoservice!
Follow these steps to unwrap the unit and make it ready for use
1 Open the cardboard box in the top
2 Tilt the box with the handle and wheels towards the floor
3 Pull the handle of the dehumidifier and wheel the dehumidifier out of the box still lying down
4 Tilt the dehumidifier to an upright position
5 Loosen the knobs, pull the handle up to the desired height and retighten the knobs
6 Remove the protective foil on the control panel
1.3 Unpacki
ngofthe unit(MK90D)
WARNING!
Ifthedehumidifierhasbeenlaiddownduringtransport,itisimperativethatyouplaceitinuprightpositionforat
least1hourbeforeputintoservice!
1Unwr
ap and lift t he box from the dehumidifier
2Li
ft the dehumidifier clear of the pallet
3C
onnect the drain outlet stub which is supplied with t he dehumidifier
1 Introduction 190TEN-1071-C1304