- 33 -
Initial Setup for Faxing
3
Faxing
Step 3-3 Specifying Sender
Information
Specify the fax number and sender name for
your machine. The information specied here is
printed on the top of the faxes you sent from the
machine.
1 Press the <SETTING> key on the
operator panel.
2 Press the to select [Easy Setup] and
press
OK
.
3 Enter the administrator password.
The factory default password is “aaaaaa”.
a Press , , , to select the
character you want, and then
press
OK
.
- The selected character is entered as “*” in
the text eld.
- If you have entered an incorrect value,
press the <CLEAR> key and then enter
the correct value.
b Repeat step a until all characters
required are entered.
c Press the and to select [Enter]
and press
OK
.
4 Press the to select [Fax Setting] and
then press the .
Note
● When the FaxServer Function is enabled, [Fax
Setting] is not displayed on the [Easy Setup]
menu. In this case, set [FaxServer Function]
to [OFF]. For details, refer to the User’s Manual
(Advanced) > “2. Faxing” > “Scan To FaxServer” >
“Enabling the Scan To FaxServer function”.
5 Press to select the [Fax Number]
entry box.
To Next Page
Loading...
Need help?
General
