- 22 -
2
Copying
2 Copying
This chapter explains the basic operation for your machine’s copy function.
Starting a Copy Job
Memo
● The following procedure uses the factory default settings.
1 Press the <COPY> key on the operator
panel to open the copy standby screen.
2 Place your document in the ADF or on
the document glass as below:
● ADF
Load documents face up with the top edge of the
documents in rst.
Adjust the document guides to the width of your
documents.
● Document Glass
Place the document face down and align its top
edge to the upper-left corner of the glass.
Close the document glass cover gently.
Note
● Do not apply an excessive load to the document
glass.
Memo
● The machine prioritizes the ADF when copying
documents. Be sure not to place documents on the
ADF when you use the document glass.
To Next Page
Loading...
Need help?
General
