The holding of measurement data
Press the data hold key "S", the reading being displayed will be held down, at this time the LCD screen will
display the data hold icon "STOP". Press the "S" key again to resume normal operation.
1. In the data holding state, a small window (dynamic data window) will appear on the upper right of the instrument's
display. The data in this window remains refreshed.
2. Once the meter enters the data holding state, the range control mode will be switched to manual mode.
3. When switching the range or changing the measurement function, the meter will automatically exit the hold state.
Measurement data storage and reading
The database of this instrument can save 100 DMM measurement data.
1. Press the "S" key to keep the current data, then press the "S" key and stay for 2 seconds to enter the database,
press the F key (SAVE) to save the current data.
2. In the database, the LCD will list the 10 storage locations on the first page and indicate whether there is a current
storage location for the data stored in these locations.
To Next Page
Loading...
Need help?
General
