MW TOOLS HB240 - 1 Important Safety Instructions; Important Notices; Qualified Personnel; Danger Notices

To Next Page

To Previous Page

M1.2.HB240-HB240M.NLFREN 21112017

1 Important safety instructions

1�1 Important notices

During the warranty period, any quality problem will be properly solved to the user’s satisfaction. However, we will not take any

responsibility for whatever bad consequence resulted from improper installation and operation, overload running or unqualied

ground condition.

This 2 posts lift is specially designed for lifting motor vehicles that weighs within its outmost lifting capacity. Users are not

allowed to use it for any other purposes. Otherwise, we, as well as our sales agency, will not bear any responsibility for

accidents or damages of the lift. Make sure to pay careful attention to the label of the lifting capacity attached on the lift and

never try to lift cars with its weight beyond.

Read this manual carefully before operating the machine so as to avoid economic loss or personnel casualty incurred by

wrong operation. Without professional advice, users are not permitted to make any modication to the control unit or whatever

mechanical unit.

For environment protection, please dispose the disused oil in a proper way.

1.2 Qualied personnel

• Only these qualied staff, who have been properly trained, can operate the lift.

• Electrical connection must be done by a competent electrician.

• People who are not concerned are not allowed in the lifting area.

1�3 Danger notices

• Do not install the lift on any asphalt surface.

• Read and understand all safety warnings before operating the lift.

• The lift, if is not specially designed upon customer’s request, is not t for outdoor use.

• Keep hands and feet away from any moving parts. Keep feet clear of the lift when lowering.

• Only these qualied people, who have been properly trained, can operate the lift.

• Do not wear unt clothes such as large clothes with ounces, tires, etc, which could be caught by moving parts of the lift.

• To prevent avoidable incidents, surrounding areas of the lift must be tidy and with nothing unconcerned.

• The lift is simply designed to lift the entire body of vehicles, with its maximum weight within the lifting capacity.

• Always insure the safety latches are engaged before any attempt to work near or under the vehicle.

• Make sure to place the lifting pads to the positions as suggested by vehicle makers and when gradually lift the vehicle to

the desired height, operators should be certain that the vehicle will not slant, roll-over or slide in lifting process.

• Check at any time the parts the lift to ensure the agility of moving parts and the performance of synchronization. Ensure

regular maintenance and if anything abnormal occurs, stop using the lift immediately and contact our dealers for help.

• Lower the lift to its lowest position and do remember to cut off the power source when service nishes.

• Do not modify any parts of the lift without manufacturer’s advice.

• If the lift is going to left used for a long time, users are required to:

a. Disconnect the power source,

b. Empty the oil tank,

c. Lubricate the moving parts with hydraulic oil.

1�4 Warning signs

All safety warning signs attached on the machine are for the purpose of drawing the user’s attention to safety operation. The

labels must be kept clean and need to be replaced when they are worn-out or have dropped. Read the explanations of the

labels on page 32 carefully and try to memorize them.