2200LZJE-HO-C6-N_2013.12.
Chapter 5 Maintenance
Compound 2-stage Screw Compressor 2016**C 5.6 Overhaul
5-14
5.6 Overhaul
Before starting inspection/maintenance, be sure to cut off the main power supply
and control power supply. Be careful that the power will not be turned on during
inspection/maintenance.
If the power is turned on during inspection/ maintenance, the compressor or oil
pump may start moving, which may cause the operator to be caught in or the
devices to be damaged. In addition, there is a risk of receiving an electric shock
through contact with live parts.
Be careful so as not to receive an electrical shock when turning on/off the power
supplies.
When handling heavy objects, exercise extreme care and use apparatus such as
crane as necessary. There is a risk that the compressor's main body or parts may
drop on human body.
When using a crane, allow only qualified personnel to operate it. Entrusting the
work to unqualified personnel may result in fall accident.
Replace the parts with genuine parts. If parts other than genuine
parts are used, there is a risk of the compressor and equipment being damaged
or ruptured.
For compressor disassembly/assembly, use specified tools that are properly
functioning. Using tools that are worn or damaged or that are unsuitable for the
work, can result in injury.
Be careful with handling of the parts during overhaul work. Since the compressor rotates at a very high
speed, even the slightest handling error could cause a situation that requires replacement of the rotor
and all other important parts. Such errors can also cause problems or performance deterioration after
the compressor is reassembled.
Be sure to fully understand the following before starting the work.
To Next Page
Loading...
Need help?
General
