To Next Page

To Previous Page

Chapter 7

Wiring

7.1 Safety Instructions 7 - 3.......................

7.1.1 Interlock Circuit 7 - 3..................

7.1.2 Emergency Stop Circuit 7 - 3...........

7.1.3 Start Up Sequence 7 - 3...............

7.1.4 Momentary Power Failures 7 - 4........

7.1.5 Protecting Power Supply and

Output Sections 7 - 4..................

7.2 Wiring the Power Supply to the Control Unit 7 - 5.

7.3 Grounding 7 - 7...............................

7.4 Input Wiring 7 - 8.............................

7.4.1 Sensors 7 - 8.........................

7.4.2 LED-Equipped Reed Switch 7 - 9.......

7.4.3 Two-Wire Type Sensor 7 - 9............

7.4.4 LED-Equipped Limit Switch 7 - 10.......

7.5 Output Wiring 7 - 11...........................

7.5.1 Protective Circuit

for Inductive Loads 7 - 11..............

7.5.2 Precautions for Using

Capacitive Loads 7 - 12................

7.6 Wiring the Terminal Type 7 - 13.................

7.7 Wiring the MOLEX Connector Type 7 - 15........

7.8 Wiring the MIL Connector Type 7 - 17...........

7.8.1 Contact Puller Pin for Rewiring 7 - 18....

7.9 Wiring the RS232C Port 7 - 19..................

NAiS FP0 Series User Manual

Questions and Answers: