NAiS FP0 Series

Table of Contents
FP0
vi
Matsushita Automation Controls
4.2.3 Analog Output Specifications 4 - 8.................................
4.3 A/D Conversion Characteristics 4 - 9.....................................
4.4 D/A Conversion Characteristics 4 - 12....................................
4.5 Wiring 4 - 13.........................................................
4.5.1 Analog Input Wiring 4 - 13........................................
4.5.2 Analog Output Wiring 4 - 14......................................
4.6 Boosting the Precision of the Thermocouple Range 4 - 16..................
4.7 Averaging Function 4 - 17..............................................
4.7.1 Averaging for Voltage Ranges and Current Ranges 4 - 17............
4.7.2 Averaging for a Thermocouple Range 4 - 18........................
Chapter 5 I/O Allocation
5.1 I/O Number 5 - 3......................................................
5.2 Control Unit 5 - 4......................................................
5.3 Expansion I/O Unit 5 - 5................................................
5.4 Analog I/O Unit 5 - 6...................................................
Chapter 6 Installation
6.1 Adding Expansion Units 6 - 3...........................................
6.2 Important Notes 6 - 5..................................................
6.3 Attachment to DIN Rails 6 - 8...........................................
6.4 Installation Using FP0 Slim Type Mounting Plate 6 - 9......................
6.5 Installation Using FP0 Flat Type Mounting Plate 6 - 10......................
Chapter 7 Wiring
7.1 Safety Instructions 7 - 3................................................
7.1.1 Interlock Circuit 7 - 3............................................
7.1.2 Emergency Stop Circuit 7 - 3.....................................
7.1.3 Start Up Sequence 7 - 3.........................................
7.1.4 Momentary Power Failures 7 - 4..................................
7.1.5 Protecting Power Supply and Output Sections 7 - 4..................
7.2 Wiring the Power Supply to the Control Unit 7 - 5..........................
7.3 Grounding 7 - 7.......................................................
7.4 Input Wiring 7 - 8......................................................
7.4.1 Sensors 7 - 8...................................................
7.4.2 LED-Equipped Reed Switch 7 - 9.................................
7.4.3 Two-Wire Type Sensor 7 - 9......................................
7.4.4 LED-Equipped Limit Switch 7 - 10.................................
7.5 Output Wiring 7 - 11...................................................
7.5.1 Protective Circuit for Inductive Loads 7 - 11.........................
7.5.2 Precautions for Using Capacitive Loads 7 - 12......................
7.6 Wiring the Terminal Type 7 - 13.........................................
7.7 Wiring the MOLEX Connector Type 7 - 15................................